cmm swan l

cmm horizontal | swan l

Horizontal arm measuring system with longitudinal X guide fixed to the side of the work surface ("Console" architecture).

CMM horizontal | swan l

The SWAN L series of CMMs with a horizontal arm installed on rails (tracks) allows the machine to be installed flush with the factory floor.

Its floor-mounted rail covers allow control of large, heavy parts resting either on a separate floor or on a ground-mounted or automated system.

"Console" architectures with integral workpiece table are extremely modular and easy to configure, providing flexibility and programmability typical of CMMs with the speed and intuitive use of traditional measuring gauges.

swan l

general features
Features and Benefits
  • Measuring System with Linear Optical Transducers
  • Motion control through servo motors D.C.
  • Sliding guides with air bearings on each axis
  • Mechanical-type head balancing with safety brake
Environment
  • Temperature: (20 ± 2) °C
  • Temperature gradient: 1 °C/hour - 2 °C/day - 0.5 °C/m
  • Acceptable vibrations:
    30 mm/sec2 between 1 and 10 Hz
    15 mm/sec2 between 10 and 20 Hz
    50 mm/sec2 between 20 and 100 Hz
Feeds
  • Minimum supply pressure: 0.55 MPa
  • Air consumption: 100 Nl/min (17 l/min at 0.55 MPa)
  • Supply voltage: 230 V 50 Hz
  • Power Consumption: 10 A 1400 W
Performance

Each COORD3 CMM is tested according to UNI EN ISO 10360-2 standards.

Options
  • Cast iron work surface
  • Linear thermal compensation
  • Models and dimensions
    COORD3 SWAN L CMMs are available with the following measuring strokes (Y.Z mm):
    12.15 / 12.18 / 12.20
    15.15 / 15.18 / 15.20
request a visit from one of our agents
We care about your data! Find out how we handle it in our privacy policy
measuring machines
coord3
We have been designing, building and distributing coordinate measuring machines (CMMs) and innovative solutions for dimensional inspection, surface reconstruction and reverse engineering since 1973.
COORD3 measurement machines and software are used by small, medium and large companies around the world to certify and improve the quality of their products. COORD3 boasts a range of CMMs that includes more than 35 automatic and manual models, from the inexpensive benchtop CMM for inspecting small parts to some of the largest Gantry CMMs ever produced.
COORD3 CMMs are in active service in aerospace, defense and heavy industry and make us proud, every day, of our work.

Strada Statale 25, No. 3 - 10050 - Bruzolo (TO) - Italy

TECHNICAL ASSISTANCE
service@coord3.com

ADMINISTRATION
finance@coord3.com

© 2023 COORD 3 S.R.L. | Via XX Settembre, 26 - 00187 Roma (RM) - Italy | REA C.C.I.A.A. No. 1667509 Rome - Paid-up share capital: Euro 50,000.00 | P.IVA\C.F: 11287420019 | SDI ZBGTBLC | ISO 9001 Certified | Privacy Policy | Cookie Policy